How to install and clean the boiler economizerIssuing time:2021-06-23 14:59 The economizer is one of the main machinery and equipment in the boiler ignition management system, which is located in the winding flue at the end of the boiler. It is the heat exchanger of the heat supply and drainage of the flue at the end of the boiler It is to the assembly before the need to calibrate the school pipe should be firm its flatness is not more than 5 mm construction line limit deviation is not more than 1 mm in the school pipe way according to the engineering drawings to terminate the construction of the layout of the pipe design limit and engineering drawings do not conform to the termination of calibration Then it is to the installation of low temperature section - medium temperature section - low temperature section from the bottom to the end of the project construction, and it is to choose the chip hoisting assembly welding. Before the serpentine tube row is announced to be in place, the beam plate and drum are fixed and then installed along the total wide azimuth 2 rows in the middle of each row. If the parts are wider in the middle, a row of serpentine tubes can be installed as a standard pipe Therefore, it is necessary to set up anti-falling net around the construction of the project. The spacing of anti-falling net on each layer should be carried out in accordance with the safety standards. The economizer serpentine pipe through the ball after the branch pipe should be temporary plugging. There should be ground skid - proof and collision - proof way when hoisting |